Drip systems are one of the most widely used types of hydroponic systems around the world, both for home growers as well as commercial growers alike. That’s mainly because it’s an easy concept and needs few parts, but yet it’s a very versatile and effective type of hydroponic system. Even though it’s an easy concept, it won’t limit your imagination when building your own systems. The way a drip system works is just like it sounds, you simply drip nutrient solution on the plants roots to keep them moist.
Hydroponic drip systems can easily be designed in many ways, as well as from small to large systems. But their especially useful for larger plants that take a lot of root space. That’s because you don’t need large volumes of water to flood the system, and the drip lines are easy to run over longer spaces. As well as when using a larger amount of growing media for larger plants, more growing media retains more moisture than smaller amounts, and that’s particularly beneficial to large plants because it’s more forgiving to the plants. Forgiving meaning that the plants arent as sencitive to watering times, so they don’t stress imeditaly if they don’t get waterd on time for one reason or another.
How a hydroponic drip system operates is simple. Water (nutrient solution) is pumped up from the reservoir through tubing to the top of the growing media (where the plants roots are), from there it drips out of the tubing onto the growing media. The nutrient solution drains down soaking both the roots and growing media all the way to the bottom of the container. From there the nutrient solution flows through an opening/s, and gravity allows the nutrient solution to flow downhill through tubing all the way back to the reservoir. It’s important to remember that the plants growing container needs to be at least 6-8 inches or so above the top of the reservoir, so that gravity can drain the excess water back do the to it (water wont flow uphill without a pump).
Like any hydroponic system that recirculates, a recirculating drip system’s nutrient solution can change in both the pH as well as nutrient strength levels as the plants use up the nutrients in the water when it circulates over and over. Because of this, recirculating systems require that you periodically check and adjust the pH as needed, as well as change the nutrient solution regularly to maintain a balanced nutrient solution for the plants.
Non-recirculating/non-recovery drip systems
For commercial growers the non-recirculating/non-recovery drip systems are most common. While it sounds like a waist of water and nutrients not to recover and reuse it, commercial growers actually waist very little. They do this by precisely timing their watering cycles. Using special “cycle timers” they can adjust the watering times down to the minute, or even second if they need to. They water just long enough to wet the growing media. So the water (nutrient solution) they drip onto the plants is absorbed and held in the growing medium where the plants roots access it, and very little if any runs off. From time to time they flush the growing medium with plain fresh water to avoid nutrient build up in the growing medium over time.
The nutrient solution in non-recirculating/non-recovery drip systems tend to be less maintenance, mainly because of the fact that none of the used nutrient solution is recycled back into the reservoir. This means that you can fill the reservoir with a balanced, pH adjusted nutrient solution and it won’t change, so you don’t need to keep monitoring it. As long as you keep the water in the reservoir slowly moving/circulating so that the heavier mineral elements don’t settle at the bottom, it will remain a balanced pH adjusted nutrient solution.